How to Crop an Image when taking a picture?

Step 1: 
 Tap the Job which the Inspection will be performed on. 

Step 2:

Tap the Camera icon to scan the asset barcode.

Step 3:

Point the camera at the barcode to scan.

Step 4:

Tap on the Checklist to begin as shown on the below screenshot.

Step 5:

Where applicable, tap on the View example button.

Start with the first checkpoint and Select either PASS, FAIL or N/A.

Under Evidence, if the Check requires an image, you may add up to seven images.

Under Findings, if the Check requires Findings (Comments), you may add your comments and findings there.

Complete all fields and tap Next to proceed to the next checkpoint.

Note at the top of the screen, once a checkpoint is completed, if it had passed, it will turn green.

You can tap on the Checklist progress bar, top right, to see checklist progress

The checklist progress screen will come up. 

 Note at the top of the screen, once a checkpoint is completed, if it has failed, it will turn red.

 
When done, the Checklist progress screen will come up. You can tap on any of the checkpoints to make sure that the information is correct or make any required changes.
Tap on and note that if NA was selected for checkpoint, it will turn orange.

Step 6:

On the End of Inspection screen, note that the checklist will reflect 100% complete.

Tap on Technician Signature if it is required. This will show on the Inspections report.

Tap on Approver Signature if it is required. This will show on the Inspections report.

If there are any Additional Technicians who worked on the Inspection, they can also sign, up to 5 additional signatures can be captured.

You may add Closing comments, these will form part of the Inspection report.

Tap on Submit & Close Inspection to close the Inspection.

On the pull-down screen, select Close Inspection.

Once the Inspection is closed, the progress bar on the inspection will show green and how many inspections have synced.